HMZ 1 Plans – Wheel Bearing Mount HMZ 1 Plans – Wheel Bearing Mount
     This wheel bearing mount gets welded to the Carriage cross member  when completed.      The hole diameter and bolt pattern on... HMZ 1 Plans – Wheel Bearing Mount

 

 

Wheel Bearing Mount

 This wheel bearing mount gets welded to the Carriage cross member  when completed.

 

 

Front View

 The hole diameter and bolt pattern on this face will be determined by the wheel bearing that you get.

 

 

Side View

 I used 4″ steel Angle for the surface that the bearing mounts on.  You could also build it from steel plate welded at 90 degrees.

 

Top View

 The wheel tracking angle is adjusted by loosening the 2 bolts slightly, then move the wheel to the desired angle and then re-tighten when desired angle is achieved.

**TIP**  If you want a fine adjustment you can make up a quick adjuster by taking a piece of threaded rod with a nut to place between the frame and the wheel.  Make your fine adjustment, re-tighten bolts and then remove the threaded rod.

 

HMZ-1 Sawmill Plans Main Page

 

 

To download the plans for the dunk tank, click the button below:

 

Required Parts to build this project:

 

jrush331

  • raymondjamesfrost@yahoo.com

    January 14, 2016 #1 Author

    You put tracking on both wheels?

    Reply

    • jrush331

      January 30, 2016 #2 Author

      No, Tracking was only on one wheel.

      Reply

      • ray

        February 15, 2016 #3 Author

        Thanks, I saw your other comment to me about no camber adjustment. I also found your other videos/pics on homemadezone. Thanks for sharing!

        Reply

Your email address will not be published. Required fields are marked *